 | |  |
11 January 09: Phase I - The man is there for scale. This is just the skeleton of the ship; I'm building from the inside out.
| |
Top, front - I'll be starting on the outside next; it'll be red with a white stripe. I have very little idea of how it will look. This is an experiment...
|
 | |  |
Main Engines - When I first saw the rubber band holders I thought they'd make great engines; this was my chance to test the idea. (I like them.)
| |
Same view... just a bit wider
|
 | |  |
Front - In the middle is a big gun, to the sides are thrusters. Between these will be an interior.
| |
Bottom - The main engines have an extra port at the bottom for take off.
|
 | |  |
21 January 09: Phase II - As promised, colour! Several in fact! As you can see, I'm not finished yet.
| |
Shuttle - Up front is a removable shuttle.
|
 | |  |
My next job is to cover the directional thrusters. They should end up around twice the size.
| |
To the starboard side is planned a cargo area of similar size. This might be skipped if time is tight. I really don't want to though.
|
 | |  |
Shuttle: Mated - When mated this is used as the pilothouse of the ship; the command center will be in the main body of the ship.
| |
Shuttle: Mated - The shuttle's weight is completely suspended by the grey docking clamps. I wasn't sure if I could make this strong enough without technic re-enforcement, but so far it seems OK.
|
 | |  |
Airlock: Closed - I really wanted to have two space pods (similar to what's in 2001) but I realised that it would take too long to design those as well as the needed hatch. Thus I put the probes here, instead of on the top and bottom as planned. These stay in place with pinned plates.
| |
Airlock: Open - You won't see the airlock top in the finished version!
|
 | |  |
Here the shuttle has been removed. The grey projections hold the shuttle in place. The yellow door was a failed concept that I still hope to find a use for...
| |
Probes - The idea is the black are more used for secret missions, and the yellow are used when they want to be seen...
|
 | |  |
Shuttle: Rear - There is access via the rear to the main ship. I don't like this hatch much, but since we have only three photos it isn't that big a deal; nobody will see it! I'll try to work out a better solution later but it's hard due to the available room. You can also see two of the 'Door Rail' pieces here that slides into the docking clamps.
| |
Shuttle: Front - The nose piece is another piece that I saw as a ship piece straight away but haven't found an excuse for yet. I was going to use that trick in Impartial II, but I'm not sure now. (It's from the ice hockey sets...)
|
 | |  |
26 January 09: Phase III - I've skinned the main directional thrusters and finished the tops and sides. More detail might be added if time permits, but I doubt that will be the case.
| |
Rear - The sides turned out largely as planned... but some of the detail I wanted to add hasn't happened as I didn't have as much of certain pieces as I thought I did.
|
1 2 Last (34 Images) |
|
| Last updated 1 Feb 09 |
For software As Compact As Possible
